3D Black and Gold Christmas Bell Dangler Embellishment
Based on my own original 3D embellishment design, this time as a dangler card. Make up the 3D embellishment as per my tutorial, using just the 7 pieces on the right hand side of the sheet.
Cut out the aperture in the card front.
Use the 8th bell from the centre of the aperture as the backer bell, adding your dangler ribbon or cord before adhering to your 3D embellishment.
Then just attach the dangler 3D embellishment in the aperture of your card. Some decoupage is also included to add that finishing touch. If you like this why don't you go and check out all my other original 3D embellishment designs. Just click on my name and have a browse.
Photographs from the Community (1)
I printed this sheet onto good quality photo paper and cut out all the parts. I attached the main picture to a card blank ans cut out the aperture. I made up thr bell and before sticking the last part, I attached a piece of ribbon.
I fastened the other end of the ribbon to the inside of the aperture. I also added a gold border and a gold ribbon.
