Fancy and layered to add to your own card designed base...
Fancy Doily 1
Photographs from the Community (4)
This is a really pretty design. I used different colours of 200gsm cardstock and let my Cameo cut the design out. I used 3d foam pads on the bottom sheets but used invisible glue on the top sheet.
I cut the doily using pink glitter card & white card. I layered up using 1mm fam pads then added a white rose embellishment to the centre. I then added to a card made with a topper from stash.
I printed onto good quality card in white and peach I used foam pads for the layers lastly added some gems and card candy a stunning design.
This is such a pretty design that I decided to make a "white on white" card with it, with just a little silver mirror paper as a highlight.
For this card I cut every layer out of the same sheet of 216gsm, linen textured, white cardstock.
The design cut very well in my ScanNCut with the base layer being around 5.5"" accross. For a base card I used an 8" square white card. I cut a panel of white cardstock at 15cm square and a silver mirror paper panel at 16cm square. I used a corner punch on the corners of the base card and the white mat.
The mats were then stuck in place using finger-lift tape and I also attached the base layer of the fancy doily using finger-lift tape.
I then used 1mm deep, double sided, foam tape to attach the next two layers and glue gel to attach the top layer.
I punched some stars out of the silver mirror paper using the same corner punch I'd used previously, and stuck these at the top corners of the base card and the centre of the doily.
I didn't add any other embelishment and I've not put a greeting on yet as I don't know what language the card will be needed in.