Rose Pink Lady and Lace with Decoupage
This is a vintage portrait of a lady in pink, with rose and butterfly decoupage.
There is also a small gift tag, or you can use this tag on the inside of your card to embellish your insert.
The sentiment tags say,
Happy Birthday
With Love
Best Wishes
Happy Mother's Day
and a blank tag for you to add your own sentiment.
To make this sheet print on quality photo paper, cut around all of the pieces, use foam squares ( or your preferred method) to stack the layers, to the main large piece, as in the photo.
Use DSTape to mount the finished topper to a blank card front that you have sized and measured to make sure that it looks and fits correctly.
Enjoy
Photographs from the Community (5)
After printing the sheet onto smooth white cardstock, I cut out all the elements, but saved one layer of the rose with the butterfly to place inside the card (in the bottom RH corner).
I then mounted the rest of the items with foam tape.
I cut a mat of lovely silver glitter paper to the same size as the base topper and off-set them on the front of an 8 x 8 Crafty Bob's white scalloped edge card base.
I added a silver peel-off down the LH side, some hot pink Liquid Pearl dots to the RH side corners and one on the sentiment tag and a number of varying sized Onyx (black) Liquid Pearl dots on either side of the stunning lady.
To finish off the card, I mounted the gift tag onto the same glitter paper and mounted it in the centre of the LH inside.
Hope you all like the end result! Check out my homepage for other items I have crafted.
Printed on good quality photo paper cutout and added a lace border I then layered decoupage with foam tape and attached to a black card to complete this stunning design.
Printed design onto 130gsm inkjet paper and mounted main design onto pink card stock. Applied 3D with foam pads, enhanced design with crystalline glitter, a silver sticker greeting and borders.
I printed this lovely design onto good quality photo paper then mounted onto pink card. I added decoupage using 2 mm thick foam pads
The design was printed on to matte photo paper and cut out.
I added a contrast panel to a 7x7 card then added the main image with foam tape.
The other elements were added with foam pads.
To finish the card I added a matching bow, flat back gems and a printed verse inside.
Thank you for the beautiful design. x