Panda-monium Roll Around 3D Card TopperCompleted by Pam Stubley

I printed this sheet onto photo paper and cut out all the pieces. I then made four pin holes on the tab fold lines, turned the piece over and scored on the reverse side - I have found this is a great way of getting rid of cracking.

I then added all the decoupage using foam pads. I took a white base card and covered it with a lovely baby paper before attaching the panda using a wet glue.

To finish I added a 'Happy Birthday' banner and a chip board, glittered number 2.

This is such a very easy card to make and is so different from any other - clever but simple - I like that and I am sure you do too.

If you have not tried this type of card I urge you to do so - you will not be disappointed!!