Victoriana Christmas SoireeCompleted by Teresa Savin

I printed the sheet twice on decoupage paper and once on vellum. I made the base card with two sheets of pearlised card and one sheet of acetate. The back sheet is folded over i/2 inch.

All 3 sheets with the acetate on top are joined together with brads down left hand side.The back sheet of card and the acetate were cut to size.

I layered the vellum picture onto the paper picture and then onto gold card with a 1/2inch border and attached to the front sheet of card.

This gives a lighter finish to the back ground.

I used the remaining images on the paper sheets to 3D the people and stuck them on to the acetate sheet using silicone glue.

I also cut 1/2inch strips of gold card to make the picture frame and mitred the corners. These were also stuck onto the acetate with silicone glue. I then decorated the frame with peeloffs. The sentiment was made in the same way.

I finished the card with some pretty ribbon down the left hand side over the brads. The "bow" was made by knotting a small piece of the ribbon round the strip.