Aperture-square Table-card Mini Kit PoolCompleted by Margaret McCartney

I printed the design onto good quality photographic paper and cut it out. I cut around three sides of the opening on the front part of the design as instructed. I attached the front of the design to an 8x8 card landscape.

I pulled down the opening on the front of the design and cut out the white area of the card.

I then attached the insert to the inside of the card being careful to line the square with the opening on the front.

I then cut the slit along the bottom of the square on the insert.

This allows the panel from the front of the card to slip through the slit on the insert making the table.

I assembled the decoupage using thin foam tape. I pulled the table out of the insert and made two slits to hold the pool balls. I threaded them through the slits and secured on the underside using strong double sided tape.

I then slid the table back through the insert to create the finished card. I cut away the remaining white areas of the card as instructed. Great concept and good fun to make.