Vintage Lady Gloves
Vintage Lady Gloves: 4 sheets for print with decoupage for 3D effect plus 1 sentiment tag (for your own personal text)
Photographs from the Community (3)
I resized this design to print C5 size and then I printed it onto good quality 255gsm photographic paper and cut it out.
When I cut out the front panel I left some white paper to form a tab so that I could attach it to the background paper.
I assembled the decoupage using thin foam tape. I added the butterflies using silicone glue. I added some white card to the back to give support to this gorgeous design. If preferred you could attach it to card and cut away the white areas on the front to form an over the edge card.
I printed onto glossy photo card. I attached the shaped front to a cream card blank using DST & wet glue. Once dry I trimmed around it. I attached the backing sheet to the inside back of the card using DST.
I assembled the decoupage elements using 2mm foam pads then finished by adding mulberry roses to the wrist using my hot glue.
A gorgeous design & very easy to make.
I reduced the size before I printed out onto 200g paper. I also reversed the front and printed so I could attach to the back of the front piece. I used foam pads for the decoupage.
Then I used lots of stickers and perlen pen onto the back and front of the card. A very special card.
More Products from AS Snezana Cards
