3D Cracker and Easel Card-snow BuddiesCompleted by Pam Stubley

I printed all the components for the card onto 200gsm photo paper and the cracker onto 160gsm card.

I cut out all the pieces and assembled the card adding the topper to the easel using dst and all the decoupage using foam pads ( I say all the decoupage but there was so much I felt I had to leave some off because of the price of postage) I made up the cracker and added the figures and tied it up with red ribbon.

A very cute card and with the added bonus of a cracker which will hold some small treat for the recipient