Age Matters Not, Star Wars 8

I printed this on 190 matt photo paper and cut out then glued to 8x8 card decoupaged with 3mm foam tabs added silver glitter to star wars with a diamond gem in each corner and on either side of the sentiment

I printed the insert panel onto 160gsm paper, the card base image to matte photo paper and the figure and greetings onto glossy photo paper.

I also printed two light swords from glossy paper as a special request from the little boy in question.

I attached the base image and personalised insert panels to a white 8 x 8 cardblank with dst. I added the sword to the left hand with dst and built up the figure with 2mm foam pads for a great 3D effect.

I added personalised greetings in french using thin foam and embellished the background with silver holographic stars. I have also shown the mini greeting card.

A fab design for a young fan!

I printed onto Crafty Bob's photo paper and cut out all pieces. I matted the base layer onto Silver Mirri card with d/s tape and added to a White card base.

The decoupage was added with foam pads, after matting a Greeting Tag and the Star Wars Tag onto Silver Mirri card with d/s tape and cut out they were then added to the front of my card.

To finish I used the Matching insert inside and added a small Topper to the reverse of my card. This is a great design for Star Wars fans.

I printed the insert panel onto 160gsm paper, the card base image to matte photo paper and the figure and greetings onto glossy photo paper.

I also printed two light swords from glossy paper as a special request from the little boy in question.

I attached the base image and personalised insert panels to a white 8 x 8 cardblank with dst. I added the sword to the left hand with dst and built up the figure with 2mm foam pads for a great 3D effect.

I added personalised greetings in french using thin foam and embellished the background with silver holographic stars. I have also shown the mini greeting card.

A fab design for a young fan!

I printed the insert panel onto 160gsm paper, the card base image to matte photo paper and the figure and greetings onto glossy photo paper.

I also printed two light swords from glossy paper as a special request from the little boy in question.

I attached the base image and personalised insert panels to a white 8 x 8 cardblank with dst. I added the sword to the left hand with dst and built up the figure with 2mm foam pads for a great 3D effect.

I added personalised greetings in french using thin foam and embellished the background with silver holographic stars. I have also shown the mini greeting card.

A fab design for a young fan!

I printed onto Crafty Bob's photo paper and cut out all pieces. I matted the base layer onto Silver Mirri card with d/s tape and added to a White card base.

The decoupage was added with foam pads, after matting a Greeting Tag and the Star Wars Tag onto Silver Mirri card with d/s tape and cut out they were then added to the front of my card.

To finish I used the Matching insert inside and added a small Topper to the reverse of my card. This is a great design for Star Wars fans.