Christmas Wreath Builder Robin Mini Kit

I printed onto Crafty Bobs matte paper,attached the front of the design to a 6x6 card blank and trimmed to shape....you do not have to do it this way as the design prints as a cut and fold card so you could just cut out and fold!...I used 3d foam pads to 'build the wreath' and glue gel to add the flowers and give shape to the bow.A touch of glitter to the snow on the branches and a couple of red pearls was all i added to finish this beautiful design.

I printed this kit onto 200gsm photo paper and cut out all the pieces. I scored and folded the base card and added all the decoupage using foam pads. I finished by adding a sentiment and gold stickles to the centres of the flowers.

A beautiful card which is quick and easy to make.

Firstly I printed the sheets onto 160 gsm card, then rough cut the main card and lined it with a printed craft paper before cutting it out properly to make the octagonal shapes.

The craft paper liner gives the card extra strength.

Next I cut out all the decoupage pieces and assembled them on the card front using foam tape to achieve depth and height.

For the snow on the twig I added a little glitter and I also put some dimensional glue on some of the red berries to highlight them.

A stunning Christmas card.