Bohemian Christmas 3d Vase and FlowersCompleted by Margaret McCartney

I printed the design onto good quality 255gsm photographic paper and cut it out. I printed the vase and liners onto 300gsm card cut these out. I cut, scored and assembled the vase as instructed. I added the liners then assembled the vase using strong double sided tape.

I assembled the flowers using thin foam tape and silicone glue on the large flowers. I attached them to long wooden skewers. I attached the panels to the vase using strong double sided tape. I attached the base panel to the vase using strong double sided tape.

I then put some Styrofoam into the bottom of the vase and stuck the wooden skewers into this to hold the flowers in place.