Bohemian Christmas 3d Vase and Flowers
Make this beautiful Christmas Vase and Flowers. In unusual contemporary Christmas colours. All the flowers and foliage in the picture are included in the kit. With easy cut borders on the foliage, for those who don't like 'fussy cutting.' Or cut into the foliage for a more realistic look. The Poinsettias are in four separate layers for you to curl the petals and make them more dimensional. Use floristry wire or skewers for the stems, add your own pearls to the centres if you wish, the choice is yours.
This will make a lovely decoration, table centre piece or gift. There are two different gift card designs also included.
Check out my other designs in this range too.
Photographs from the Community (1)
I printed the design onto good quality 255gsm photographic paper and cut it out. I printed the vase and liners onto 300gsm card cut these out. I cut, scored and assembled the vase as instructed. I added the liners then assembled the vase using strong double sided tape.
I assembled the flowers using thin foam tape and silicone glue on the large flowers. I attached them to long wooden skewers. I attached the panels to the vase using strong double sided tape. I attached the base panel to the vase using strong double sided tape.
I then put some Styrofoam into the bottom of the vase and stuck the wooden skewers into this to hold the flowers in place.
