Stargazer Lilies Flower Arch 3D Card KitCompleted by Hand Made Finished Cards By Dianne Jackson

I printed onto 250 gram smooth card and printed the backing sheet onto 2 of the sheets. I made up following the simple instructions but I did not add the flower arch back to back as I had printed the backing sheet on the back so this was not needed.

I cut the slits to slot the arch into place and then covered the cut slit with some flowers from the back arch that I did not use.

I decoupaged the flowers and pyramid layers using sticky pads and added a birthday sentiment to the back. I added 2 small lilac organza ribbon bows and spotty design card candy to finish off this very pretty design