Mini Car Birthday or Fathers Day Appeture Topper and Insert
This is an aperture type of topper and insert. Cut out the aperture (image on the left) around the tires and car where there is white showing. You can then use this as a template to cut your card front where the aperture is.
Then put the aperture image (one on the left) onto your card front using Foam pads or doublesided tape.Make sure to centre the insert on the inside of your card so that the apeture opening is over the insert.
There are two sentiments for this topper set Birthday or Fathers day. The topper will fit roughly a 6x6inch card.
Photographs from the Community (2)
The image was opened in PhotoShop and I added a greeting on the inside element of the card. It was then printed onto good quality A4 card and all layers were cut out and decoupaged using 3D foam pads.
The white area on the card front was cut out so that the inside of the card can be seen from the front.
I then scored the back of the card and creased it before using DST to attach it to the front of the card.
I love this card!
The image was opened in PhotoShop and I added a greeting on the inside element of the card. It was then printed onto good quality A4 card and all layers were cut out and decoupaged using 3D foam pads.
The white area on the card front was cut out so that the inside of the card can be seen from the front.
I then scored the back of the card and creased it before using DST to attach it to the front of the card.
I love this card!