Wife Wedding Anniversary Card
A beautiful card with a lovely crimson rose arrangement and champagne glasses. There are cutouts to make these 3D. It looks very nice when completed. This design will fit a 6 x 6" card or can be resized. I hope you enjoy making it!
Photographs from the Community
Printed out onto white card and cut out all the elements. I used a Tonic decorative punch on the bottom edge of a white 8x8 scallop edged card and then placed the base image onto the card using d.s tape and then added the remaining pieces using foam pads.
I added some red floral gems to the punched border to finish. The insert has has been left blank so that my customer can write their own message.
Printed onto decoupage paper. Placed the base image onto my card with tape and then added the layers using foam pads. I added peel-offs to the card.
I attached the base using DST and cut out all of the elements before deciding it would be better to mount the champagne glasses first
I printed it out onto 220gsm card. I attached the main part with double sided tape onto card, the layers were attached by sticky 2mm tabs.
Approx 18cm x 18cm
The inside is blank for your own message.
Approx 14cm x 14cm
I printed it out onto 220gsm card. I attached the main part with double sided tape onto Silver foil card and then onto a approx 18cm x 18cm card, the layers were attached by sticky 2mm tabs.
The inside is blank for your own message.
Approx 14cm x 14cm
I printed it out onto 220gsm card. I attached the main part with double sided tape onto Silver foil card and then onto a approx 18cm x 18cm card, the layers were attached by sticky 2mm tabs.
The inside is blank for your own message.
Approx 14cm x 14cm