Lace Frames - White
3 lace frames for you to use on your crafting projects. They are 300dpi png files with transparent backgrounds.
Photographs from the Community (2)
I used the largest square of these beautiful lace works for edging my Christmas card sheet. It is very easy to do with only a few pieces of decoupage and you can add some of your own bling to it if you wish.
If you like the design you will find it on cup554070_1716 when validated
I took one of these lace mats, plus 2 of the crosses from cup553422_543, into one of my graphics packages.
I resized the lace mat to be smaller than the size of an A5 card front and then layered up the two crosses on top, making the top one off-set to the one below.
I also put a 2nd copy of the topmost cross to one side of my working area. The sheet was printed out onto 250gsm Super Smooth white cardstock.
The card front was cut out around the outside of the lace panel and the butterflies were cut out of the 2nd cross.
I used 2mm deep, double sided, foam tape to attach the topper to the card front, and glue gel to attach the butterflies after I'd shaped their wings.
I finished off with a greeting "Gair o Gysur" - which is Welsh for "A Word of Sympathy" which I'd cut out of silver holographic peel-off sheet using my ScanNCut.
