B is for Baby CardCompleted by Key Lime Pi Designs

I'm new to machine cutting so was a bit nervous about the lace effect, but think this turned out beautiful.

All the white parts will fit on one 12x12 sheet, and you can get two sets of colored pieces from one 12x12 sheet.

After cutting, I assembled the card and added a ribbon bow. I used hot glue between the bottom 2 layers to give some lift, but not so much as foam tape would give.

A few hints if you're also new to this: Make sure your sitcky mat is sticky as you don't want the paper to lift up at all, and it also helps pull out the little holes from the lace.

If you don't have a purchased scraper, an old plastic credit card works great to push the holes off your mat.

If you use textured paper for the lace pieces, be sure to have a very sharp blade. As a bonus, the words could be used on other cards.

Love this card!