Flower Filled Wheelbarrow Tunnel Topper
A really easy Tunnel quick card topper design that is just under 10 x 10 cm just cut out the tunnel layers and add using foam tape or silicone to create a stunning 3d effect that draws your eye to the centre.
Three small matching toppers that are approx 6 x 6 cm are also included on the sheet, these can be used on their own or inside or on the back of your card, and would also make great gift tags too! Or why not include your contact details on the back of one the toppers, and pop in with your finished card ... for future orders!
This design is also available in other coordinating designs/colourways and together they would make a great set of cards to sell at craft fairs etc.
This design is great for female birthday cards but is also suitable for lots of occasions including Wedding Cards, Engagement Cards, Anniversary card, Mothers Day card, Anniversary Cards, Invitations, rak and swap cards etc
Photographs from the Community
Printed onto glossy photo card and cut out all the invertage layers with a craft knife and metal edged ruler.
Very quick to cut out as the 4 parts are lined up perfectly on the sheet.
I used a cream square card blank and stuck some patterned backing paper using double sided tape. I matted the 1st invertage image (the complete picture) onto silver mirri card, again with dst. I then used foam pads to add the layers. I finished the card with a bow, cream pearl gems and a sentiment.
A lovely sized image which is very quick to make and such good value as after making up the invertage pyramid, there are still 3 toppers left for other cards.