Vintage Butterflies 3D
Layer the butterflies and make your own beautiful cards!
Photographs from the Community (2)
After printing onto 160 gm paper I cut out all the pieces. The panel, backing (cup189120_566) and two main pieces with flower stamen feelers glued on were added using dst.
The remaining pieces were layered using 2mm foam pads to the outside edge of the wings and dst to the bodies.
Finished with silver peel-offs.
I glued a backing sheet onto photo paper and glued it onto cardstock.I then glued a wide ribbon down the middle tucking the ribbon ends underneath the backing sheet and then glueing it onto a card..I printed the sheet onto photo paper and using foam tape ,attached them onto the card.I just put a piece of foam tape in the middle of the smaller butterfly and bent the wings up.I then put the smaller one on top of the middle one and finished with glitter and a sentiment.
More Products from Marijke Kok