DIY Tool Kit ToppersCompleted by Gwyneth George

The sheet was printed onto super smooth white card and the pieces cut out. I made two cards from the sheet, on a small square card and the other, as shown above, an A5 card.

I took an A5 white card and stuck on some backing paper of a hammer hanging from a toolbelt. On top of the backing paper I stuck an oblong of rib textured gold card. The two toppers were stuk on top left and bottom right, together with the blank greetings panel. I then stuc on the decoupage elements using 2mm deep double sided foam tape.

I finished the card off with the matching insert.