Birthday Rose Toppers and RibbonsCompleted by Gwyneth George

I printed the sheet onto Super Smooth white card and cut out each of the rose panels and ribbons. For this card I took a 6" square hammered white card.

I trimmed a piece of velum, printed with a flower pattern in gold, to just fit the card leaving a small white border.

I attached the velum to the card using a roller glue pen at the centre of the card.

I then attached the ribbon strip down the left hand side, some 1.5cm from the edge, using the same glue, making sure that it was glued top and bottom so it attached to the base card as well as the velum to prevent the velum from flapping.

I stuck the rose picture to the centre of the card using 2mm deep double sided foam tape. I finished the card off by putting faux yellow gems near the corners of the rose image topper and also at the top and bottom right corners.

These gems were placed over the edge of the velum to keep it in place.