Vintage Santa in Automobile - Masculine, Male ChristmasCompleted by Taina Kankare

I printed the sheet and cut out all the pieces. I searched for background paper and found some gingham paper from my stash. I attached it on a white card base leaving a 2 mm white border.

Then I attached a white paper at the back of the 3D-backing paper leaving a 2 mm white border again.

Then I used special scissors to make the border serrated. After this I attached the base 3D paper on the gingham paper. Then I attached the car layer with foam pads on the base 3D paper. I used slightly higher foam pads to attach the holly branches.