Wild Tiger Card Topper

I printed the sheet out onto 300gsm Super Smooth white cardstock and then cut out the pieces. I rounded the corners of the base layer using a punch before going around the edge of all pieces using a gold Wink of Stella brush pen to give a little twinkle.

I took an A4 sheet of Centura Pearl Snow White cardstock and scored it in half using my Hougie Board before folding it into an A5 base card.

The card front panel was attached directly to theis using finger-lift tape. I attached the three panels to this using 1mm deep, double side, foam tape. I finished off by putting dots of a brown glitter glue around the edge.