Beautiful Long Kitten Card Topper
beautiful card topper for any occasion
Photographs from the Community (2)
Printed on glossy photo paper, I cut out all of the elements and decoupaged using foam pads, I then mounted the image onto the card using dst and added silver peel offs.
This is a lovely design.
I printed the sheet off at half size onto 300gsm Super Smooth white cardstock and cut out the pieces. I used a punch to round the corners of the base layer before going round all the layers using a gold Wink of Stella brush pen.
I created a base card of a suitable size out of an A4 sheet of Centura Pearl Snow White cardstock that I scored using my Hougie Board and trimmed.
The base image layer was attached to this using finger-lift tape and the two two top layers were attached using 1mm deep, double sided, foam tape.
I finished off by going over the butterfly wings with a clear Wink of Stella brush pen.
