Unicorn (5) Camera Eye TopperCompleted by Jean-Marie Penny

I printed this onto 120gsm. I printed 2 matching backing papers, 1 'shrink to fit' and the other 'full page' A4 onto 120gsm paper. I made an 8" square (20cms) twisted easel card and mounted the 8x8 backing paper to the easel using dst.

I turned the full A4 backing paper diagonally and attached to base corner to corner using dst and cut away the excess.

I made a text plate stopper and attached with foam pads. I cut a 5.5" (14cms) square of rainbow mirri and attached it like a diamond to the easel using dst.

The base layer was mounted onto rainbow mirri with dst and the camera eye pieces attached with foam pads.

I added 4 tiny buttons to each mirri corner using foam pads. (The buttons were printed onto 120gsm paper on the smallest setting on my printer and they came out approx 1 inch (2.5cms) across).