Unicorn (1) Camera Eye TopperCompleted by Jean-Marie Penny

I printed the design and matching backing paper onto 120gsm paper. Using an 8" (20cms) gatefold card I cut the backing paper in half and attached to each front using dst.

I stuck a peeloff edge all around both pieces.

I mounted the base layer of the design onto rainbow mirri card and cut a small border. I then attached the camera eye pieces in place using foam pads, then attached the left half of it to the left hand 'gate' with foam pads.

I made 2 matching text plates and added them above and below the design with foam pads.