Caterpillar Thank You Sheet

I printed onto super smooth card and cut out all the elements. I added the "thank u" greeting with foam pads. I built up the caterpillar again using foam pads. I used the complete caterpillar then a complete layer of buttons.

For the top layer I pricked holes in the 3 large buttons and thread some wire through before adding these with foam pads and then used the 2 smaller buttons as embellishments on the front panel.

I added 3D gloss to the eyes and drew in faux stitches with an orange marker on the remaining buttons.

I mounted the whole topper onto an orange A5 card blank. This is a fun card that has lots of potential to play around with.