Barn Owl 3D Decoupage Woodland & BackgroundCompleted by Gwyneth George

I printed the sheet out onto Glossy Crafty Bob paper and then cut out the pieces. I took a 15cm square, light cream, base card and attached a panel of the background to it after trimming it to a little smaller in each direction. I then added a panel of Centura Pearl Snow White Cardstock that I'd trimmed to 3cm wide. Both the backing and panel were stuck in place using Fingerlift tape.I then attached the base image and the blank greetings panel using 1mm deep, double sided, foam tape. The decoupage layers were then gently shaped by and before attaching to the image using glue gel.

This is a striking image, and when decoupaged up you could almost believe that the owl is about to take flight and come out of the card towards you.