Winter Pub Snow Spiral Edge Stacker Card Front
I have designed this to create a spiral edge stacker around a card front. This is a 5inch x 5inch square card front, and you simply cut out the base image and attach to your card or project flat, then cut out the edges starting at number 1.
Glue your edges using a 3D glue or foam pads, and attach to the base image going around the outside, each edge overlaps the last, this will build up the outside edge into a 3D decoupage effect.
As you glue the edges you are going around the card in a spiral effect.
Photographs from the Community
I printed the images on to glossy photo paper and cut them out. Following the clear instructions I layered up the stacker with glue gel. The complete image was adhered to gold glitter card and then placed on to a white square card blank.
The main image was accented with fine glitter on the edges of the snow.