Winter Etching Ribbon Edge 5in Rounded Spiral Stacker
I have designed this new design concept to create a spiral rounded edge stacker around a card front.
This is a 5inch x 5inch square card front, and you simply cut out the base image and attach to your card or project flat, then cut out the edges starting at number 1.
Glue your edges using a 3D glue or foam pads, and attach to the base image going around the outside, each edge overlaps the last, this will build up the outside edge into a 3D decoupage effect.
As you glue the edges you are going around the card in a spiral effect.
Photographs from the Community
This design was printed on to matte photo papers and cut out. I used a 6x6 card blank with a square of designer paper on the front. I then adhered the main image with double sided foam tape. I then placed the other pieces on top.
Finished off with stickles crystal glitter, a pre printed sentiment tag and aprinted verse insert. A beautiful design and makes an easy card. xx