Holly Greeting Spiral Edge Stacker 8x8 Card Front Kit
I have designed this new concept as a kit to create a spiral edge stacker around a card front.
This is a 8inch x 8inch square card front, and you simply cut out the base image and attach
to your card or project flat, then cut out the edges starting at number 1. Glue your edges using
a 3D glue or foam pads, and attach to the base image going around the outside, each edge
overlaps the last, this will build up the outside edge into a 3D decoupage effect. As you
glue the edges you are going around the card in a spiral effect. This kit will create 3 layers for you.
Photographs from the Community
Wonderful design and picture for this card - cut out and made up as instructed - added to main card - added a red braided ribbon to out edge of inner picture - glittered the bow on main picture - spot glittered the outer edge of all the holly leaves in the four corners - added some tiny peel offs - stars inside main picture - diamonds and drops on lace edging - finished off with a red bow on bottom left corner and a red Christmas flower - lovely card to make