Just Married Wedding Car Spiral Edge Stacker Card Front

I have designed this new concept to create a spiral edge stacker around a card front.

This is a 5inch x 5inch square card front, and you simply cut out the base image and attach

to your card or project flat, then cut out the edges starting at number 1. Glue your edges using

a 3D glue or foam pads, and attach to the base image going around the outside, each edge

overlaps the last, this will build up the outside edge into a 3D decoupage effect. As you

glue the edges you are going around the card in a spiral effect.

The Designer accepts total responsibility for this product, its use and any copyright issues that arise.