Christmas Prayer Square Spiral Rounded Edge Stacker
I have designed this new design concept to create a spiral rounded edge stacker around a card front.
This is a 5inch x 5inch square card front, and you simply cut out the base image and attach to your card or project flat, then cut out the edges starting at number 1.
Glue your edges using a 3D glue or foam pads, and attach to the base image going around the outside, each edge overlaps the last, this will build up the outside edge into a 3D decoupage effect.
As you glue the edges you are going around the card in a spiral effect.
Photographs from the Community
The image was printed onto 180grm everyday, glossy photopaper. Gold glitter ribbon was applied to the sides of a 5 inch square card with glue. The main image was matted to the card with double sided sticky tape and 2mm foam pads were used for the layers.
This card is made using the Square Spiral Rounded Edge Stacker method.