Bottles of Wine Triangle StackerCompleted by Gwyneth George

The sheet was printed onto glossy photo card and the layers cut out. Two pieces of good quality white paper were also cut out the same size as the square base image and the largest triangle layer.

A piece of project acetate was taken and folded in half to make the card. The square base image was stuck to the inside of the acetate card. The same sized piece of white paper was taken and stuck to the back of the card to cover the glue and give a space for a "handmade" sticker.

The largest triangle layer was taken and stuck to the front of the card, carefully lineing up with the image inside.

Again the same sized piece of white paper was stuck inside to hide the glue and give a space to write a greeting.

I then opened out the acetate card and using a ruler along the diagonal of the image I cut the front of the card at an angle.

I stuck one of the ribbon pieces along the right hand edge of the inside card some 1cm in from the edge and an empty greetings pannel on the front bottom.

I then completed the card by building up the layers with 2mm deep foam pads.