Cute Cat Quick Card with Side Stacker Topper
A Cute Cat holding a bunch of flowers as an easy to make side stacker card. Cut out the side stacker topper strips and layer on each side of the main image for a stunning 3d effect that draws your eye to the centre.
This sheet will mix, match and coordinate with all my other Cute Cat downloads too!
This design is great for female birthday cards but is also suitable for lots of occasions including Anniversary card, Mothers Day card, Invitations, rak and swap cards etc
This design is also available in other coordinating colourways and together they would make a great set of cards to sell at craft fairs etc.
Photographs from the Community (1)
I thought an acetate bridge card would be a little bit unusual! Firstly I printed the images onto a good quality card and built the side stackers using foam tape to give a good depth.
Then I took a pre scored 6 x 6 card and cut it down to allow just a small boarder around each of the side stackers.
I then took an acetate sheet and measured with width only. I trimmed the width to allow around 1cm clear either side of the space needed for the main image and a further Icm to allow for glueing to the sides.
Using velum glue I attached the acetate to the back of the sides and then trimmed the depth to match the sides.
Finally I attached the main image to the centre of the acetate and gave the acetate an extra score to allow for the crease at the top, and decorated with glitter, peel offs , pearls and a bow.
