Birds Ornate Diamond 7x5 All 4 Corner Stacker
I have designed this stacker to give your card fronts a great look that can be built in to fab 3D image.
This is a 7x5inch image for card fronts. Simply use the base layer on your card or project then build up the corners using 3D glue or foam.
I have not included a diagram for you on this sheet but if you get stuck PM me in the forum.
Photographs from the Community (1)
I printed this sheet so the main picture measured 6cm x 8.5cm and cut out all the elements. I layered up all the pieces using foam pads and matted and layered this onto gold pearlescent card. I printed
cup218558_10 at A6 size and used this to cover an A6 card blank. I stuck some coordinating rust red ribbon with light blue dots onto more gold pearlescent card and stuck this down the middle of the card blank. Finally I attached the image to the card using foam pads and finished the design off with navy adhesive pearls.
More Products from Ann-marie Vaux
