Easter Wishes Peach Roses Scallop Bottom 7x5inch Stacker
I have designed this sheet as a bottom stacker, it is sized at 7x5inches and has a base image and 3 layers to use on top, use your 3D foam or silicone glue to build up the design for your card.
Each layer is smaller then the last and sits to the one side only on your card front, it is measured to look like a stepped effect and will make people think you have spent ages on it.
Photographs from the Community (1)
I printed out the pieces onto good quality photo printer. I added the decoupage using sticky pads. I took a cream card and some matching pinky/red paper that was the same tone as the roses on the card.
I punched a scalloped edge down the side of the cream card and started to build up the card matting and layering with gold mirri card and the toned paper.
I cut a 2inch strip of the toned paper and stuck it to the inside edge of the card so when the card is closed the it showewd through the scvalloped edge.
I finshed off with gold peel offs. This is a really pretty card and it's easy to make.
