Penguin Penny Slider

I printed this sheet out and mounted the slot and the base layer of the penguin onto thin card. I then cut all of the elements out. I cut the background paper to 19.5cm x 13.5cm and mounted it onto a slightly larger piece of black card.

I then stuck it onto an A5 card blank. I stuck two pennies either side of the slot, using two 2mm foam pads. I put 2mm thick thin foam tape onto the two long edges, making sure my penny can still roll freely.

I then stuck the slot onto my card.

I stuck the base layer of the penguin into the penny, and decoupaged the other layers using 2mm foam pads.