Bunny Birthday Slider

The sheet was printed onto super smooth white card and the elements cut out. An A5 tent fold card was taken and the backing pannel stuck to it. The outside of the backing pannel and the slider pannel were decorated with fancy, dark green, peeloffs.

The slider pannel was stuck diagonaly accross the card using 3mm deep double sided foam tape taking care to space the two strips slightly further than the width of a 1p piece apart.

Two 1p pieces were stuck together using a 3mm deep round foam pad. This was slid into place by gently opening the slot in the middle.

It was tested to make sure that it moved and span correctly before one of the bunnies was stuck on with a blob of glue gel.

The second bunny was stuck under the edge of the slider panel.