Butterbee Circle Slider

Print the sheet onto white card and cut out the main image. I matted the main image onto a pearlescent light blue A5 card.

Then cut out the slider with a craft knife. For this project I used a two pence piece as it tends to make the slider spin more as it is heavier than a penny.

Put 3mm foam tape around the edge of slider mechanism. When putting the foam tape in the middle circle make sure you put it more in the middle than the edge as you need to make sure the 2p doesn't get caught on the foam tape otherwise it won't spin.

Carefully line up the slider mechanism with the main picture. Place your 2p under the slider runway and stick a 3mm foam circle to the middle of the 2p. Now decoupage your butterbee image onto the circle foam pad.

Now enjoy entertaining your friends and family with a spinning slider card!!