Pink Violins Lace Bracket Wrap Card
I have designed this bracket shaped wrap card
for using as a quick and easy cut and fold card or
to be used with the spiral edge stackers, both wavy
and straight edge. If you cut and fold the card for a simple
look, or using the matching card front, build the
picture into a 3D front. I have included a ribbon
strip to match, to make a bow for the flaps. If you
feel like being advanced with the card, print it
twice and use the flaps on the outer side of the card.
This card measure 6inch square and the centre fits for
the 5inch square fronts I have designed already.
Photographs from the Community
The sheet was printed onto super smooth white card and the main card topper and ribbon piece were cut out.
I scored down the fold lines between the centre panel and the two side wrap panels.
I took a sheet of linen effect gold card and marked around the two side pannels and cut these out to make two pannels that would go on the outside when the panels were folded inwards.
Before sticking the right hand panel I pierced two holes on it, cut a piece of the ribbon element and put two holes through this and then used gold brads to attach the ribon to the front gold panel before sticking this to the side panel of the card topper with glue gel.
For the left hand side I folded the rest of the ribbon piece in half and put it between the gold panel and the back of the left hand side panel of the toper before I glued this the left hand side panel together.
I then attached the topper directly to the top of a cream card that is the same size as the centre panel.
The ribbon piece protruding from the left hand side can be tucked into the shorter piece. I finished off the outside with some fancy fine border peelof around the edge.