Shirt and Tie 6
A lovely shaker card where the frame is the same as the image. A little bit different from the usual frame shakers but just as easy.
Photographs from the Community (3)
I cut out all elements and layered than followed instructions to make shaker box. Very quick and easy to assemble
I printed onto good quality card stock and cut out all the pieces including the centre of the tie as instructed.
I attached the main picture to an A4 sheet of card folded in half using DST.
I used narrow DST to fix acetate to the back of the cut out tie and attached to the main picture using foam board to allow for the sequins and beads to move freely.
Using foam pads I attached the final collar pieces and the Happy Birthday sentiment. Impressive card for someone special. I have also used this without the shaker part as seen in my second photo.
I printed onto good quality card stock and cut out all the pieces including the centre of the tie as instructed.
I attached the main picture to an A4 sheet of card folded in half using DST.
I used narrow DST to fix acetate to the back of the cut out tie and attached to the main picture using foam board to allow for the sequins and beads to move freely.
Using foam pads I attached the final collar pieces and the Happy Birthday sentiment. Impressive card for someone special. I have also used this without the shaker part as seen in my second photo.
