Happy Birthday say it with flowers

The design was printed twice onto 160 gm card. One of the main pieces was cut out and mounted onto a card blank using dst. From the other piece I cut out the side flower panel and layered this using dst on the outside edge and 2mm foam pads on the inner edge. The shield shapes were cut out, one with the white border, one with the pink border and then just the flowers with a very narrow border. These were layered using 1mm foam pads and I finished with a gold peel-off sentiment. One of the smaller shields was used inside the card.

Sounds a bit complicated but its not really and well worth the effort with a fantastic design.