Polar Bear Love Topper with Scalloped Pyramage

Printed on good quality card paper cut out and layered the elements with foam sticky pads and added a Gold Valentine greeting plus the hearts on the side to decorate.

I printed this sheet on to photo paper, and cut all the elements out. I mounted the base image onto black card, and then onto a 15cm x 15cm card blank.

I attached the layers with 1mm foam pads, and the tied two bows from red ribbon, and attached them to the top of the card.

Printed this out and placed the base image onto a 6 x 6 deckle edge card ysing d.s tape. I took the largest piece of decoupage and removed the centre leaving just the frame and placed this inside the card as the insert.

The white showing through the aperture can be used by my customer to write their own message. I then added the remaining pieces using foam pads to finish the card.