Elegant Flourish Pyramage SheetCompleted by Hazel Pepper

I started with a card blank which is 15cm x 27.5cm, and I cut 2cm off the front right edge.

I printed a paper cup40480_359 - 'Copper Metallic Linen Embossed' Backing Paper, by the same designer.

I stuck a narrow piece of brown paper along the cut edge, and then stuck the paper on top, leaving a small brown border.

I trimmed off the excess and cut a 1.25cm strip off, I then stuck the remainder on the inside right of the card so it shows when the card is closed.

I mounted the thin strip onto a 1.5cm width of brown paper and stuck on the left side of the card.

I then tied a knot in a thin brown ribbon, and wrapped around the strip of paper, sticking the ends inside the card.

I then printed the design sheet twice and mounted the bottom layers onto brown paper and spaced evenly on the front of the card.

I then made the pyramages up using 1mm foam pads.