In the Stables Christmas Nativity Pyramids

The sheet was printed onto super smooth white card and each layer was cut out. To build up the card I began by cutting out a pannel of linen textured blue card a few mm taller than the base stable image and an inch and a half wider.

I ran the right hand side of this blue mat through my Creatopia to emboss stars down the side. I than stuck the base stable image onto the left hand side of the mat. I built up the pyramid using 2mm deep, double sided, foam tape.

I then wrapped a silver ribbon around the bottom and tied a knot towards the right hand side before sticking the whole blue panel and pyramid topper to a prepared cream card that had been trimmed to a few mm larger than the blue mat.

I finishd off by taking a Sakura clear stardust pen and went around each of the embossed stars with it, as well as the outside of the base layer of the stable pyramid and around the outside of the blue mat.

I also used the same pen to highlight the halos of Joseph, Mary and the baby Jesus as well as the rays from the star.