Rooftops Snow 5inch 3D Paper Weaving SheetCompleted by Annmarie Spriggs

I printed the sheet onto 120gsm white paper then cut out the two toppers along the lines indicated leaving on the tabs at each end.

I got a 5 inch square piece of card and weaved the paper onto it as per the instructions on the sheet.

Once finished i matted it onto some off white glitter card leaving a small border around the edge then matted it onto a 6 inch square red card.

As an extra touch i glued 2 snowflake embellishments i had over the 2 corner snowflakes in the image.