Ornare - Paper Piercing Abstract 1

As I alredy had a card in mind to mount this piece of Ornaré onto I slightly changed the size of the pattern before printing.

I printed onto good quality paper and then stuck this over a piece of Centura Pearl Snow White card with low tack tape before pierecing through all the marked dots.

After piercing I trimmed all around the pattern leaving a narow border. I mounted the Ornaré panel onto some deep green irridescent paper and again trimmed to leave a narrow border. This matted panel was then stuck to an 8" square card that I'd embossed a patern at each corner.

I then decorated the card with some bows I made from gold ribbon, some green, sticky back, faux green gems, some butterfly green faux gems.

In the centre of the panel I put two skeleton leaves which I attached with some green wax and a G seal.

I put some paper flowers made from white irridescent paper around the botom of this and finished off with a greetings panel.