Red Forget Me Knot Special Day 3D Pop-up Bench Mini Kit
This kit makes 1 Pop-Up card both outside and inside, it is easy to make and has a full colour photograph step by step tutorial to show you how to make it.
You get everything you need to make it including 1 x full colour photograph step by step tutorial to make it easy for you, it does look complicated but it really isn't, and the finished results are beautiful.
Photographs from the Community (2)
I printed the design onto good quality 255gsm photographic paper and cut it out. I cut, scored and folded the inside of the design as instructed.
I attached the outside of the card to the inside using double sided tape and being careful not to put tape onto the cut out area in the centre.
I added the greeting using thin foam tape. I did not use the decoupage but added flat backed pearls to the centre of the flowers to complete this gorgeous card.
It will fit into a 5 x 7 envelope.
I printed this card twice onto my favourite Crafty Bob Matt Photo card in two different sizes. I started on the bigger one but being pedantic about edges meeting and being exact, I just couldn't get it right.
So I started on the smaller one.
I made a light green card, cut the printed outside card in half and stuck the 2 halves to my green card.
I then followed the direction sheet to make the bench for the inside of my card. The directions are very clear and easy to follow. I added the Special Day panel using spongy tape.
Back to the front of the card, I used a sharp craft knife to cut out 3 of the flowers, shaped them and stuck them over the top line of flowers using spongy dots.
To add a different dimension and a touch of light, I added bling to the centres of the flowers. I added my name to the ?Made for you by? panel and sat back and admired my work. Hope you like it too.