Christmas Waterfall#1

I printed the design onto good quality photographic paper and cut it out. I scored and folded a 5 x 7 scalloped edged card. I scored and folded the waterfall element as expected and attached the three panels where indicated using strong double sided tape on the top edge only.

I assembled the decoupage using thin foam tape. I added the bar to the waterfall element using double sided tape. I made a small hole at either end and put a brad from my craft box through the hole at each side.

I then made corresponding holes in the backing paper after carefully positioning the waterfall where I wanted it to be.

I then put the brads through these holes and anchored them at the back. This holds the waterfall in place when you are pulling it. I then attached the backing paper to the card using double sided tape. The back of the brads are not now visible.

I added the greeting using thin foam tape.